Dynamic charging power management module CIRCONTROL BÉON
dynamic load management module - for terminal-phase CIRCONTROL - Beon allows dynamically manage the load on your terminal CIRCONTROL eNext Home S (single) and eHome based power available in your installation.
The kit contains 1 spool management module induction
The module informs the terminal of the current going through the cable (s) (s) in real time.
in that the terminal can adapt to the maximum power marked in the main differential of the electrical panel
The management module is installed around the stage that starts from the main differential
Example of Use
For example, if you have at home a 40A single-phase installation, and that you have connected your terminal CIRCONTROL eNext 32A single phase on a dedicated line, then there is a good chance that your main circuit breaker trips during a load because your terminal will consume more than the available power.
The load management module will allow you to avoid this problem. It connects to the power of your table, and will measure in real time the total consumption of your home including the terminal. None expected adjustment, it is already set to the desired output in the manufacturing plant, for example 40A here. The module will then inform the terminal of the current consumed by the house in real time. The terminal will use that information to adjust its power to the maximum power available, without cutting out the installation.
So if your home consumes for example 17A, 23A consume then your terminal (40-17). When your house will consume less, 5A for example, then the terminal will increase its consumption to 32A (40-5, but limited to 32A maximum load current of the terminal).